SAMSON is the professional audio equipment manufacturing company; their production of professional level microphone, earphone, words put, mixer, listening to speakers and other audio equipment for reliable quality, the cost performance is high in the industry a good reputation. Recommend to you the company production is especially suitable for computer recording mix with mainly small and medium-sized music studio chooses digital tube words put: C.V ALVE.

C.V ALVE is with digital output microphone/instrument tube pre-amplifier, pure, low noise, silky smooth sound quality is C.V ALVE the biggest characteristics. This words put to use adjustable gain and adjustable tube processing, make sound more warm, natural, full and connect fully, no matter you use which kinds of microphones, it will sound transmission have watertight and keep pure transparent quality.

C.V ALVE own 48 v phantom power supply, special optimization vocal equalizer, driver, pressure limit apparatus, phase adjustment, send/fold back pass in and out and digital output, front panel simulation VU output instrument and LED input indicating that you may intuitive control signal gain, and can be sent through fold back port and Samson C series of other hardware effectors connection.

1. the body wall
For use in high differential pressure and corrosive media occasions solenoid valve, body wall, diaphragm membrane and the impact of the media are often subject to corrosion, must focus on examination of pressure, corrosion of the situation.

2. valve seat
Solenoid valve work, because of the media into the fixed seat inner surface with a screw loose seat leaving susceptible to corrosion, inspection should be noted. Working under high pressure differential valve, check valve seat sealing surface is also washed out.

3. spool
Valve to regulate the work of moving parts, by the media, erosion, corrosion is most serious, carefully check valve when repair parts are corrosion, wear and tear, especially in the case of high-pressure differential is even more serious wear spool (due to cavitation phenomena) should be noted. Valve replacement should be carried out badly damaged, the stem should also pay attention to whether a similar phenomenon, or loose connections, etc. with the spool.

4. Patch "O" rings and other seals. Solenoid Valve shall be submitted in the diaphragm, "O"-shaped seal is aging, cracking damage.

5. sealing packing
It should be noted PTFE packing, sealing grease is aging, with the surface is damaged, should be replaced when Coach Bags necessary.

1. according to process conditions and select the appropriate structure and materials.
2. according to the technical characteristics of the object, select the Solenoid Valve flow characteristics.
3. according to process operating parameters, select the appropriate Solenoid Valve bore size.
4. according to the requirements process, select the auxiliary device.
5. reasonable choice of implementing agencies. Response speed of the implementing agencies should be able to meet the process

A solenoid valve has two main parts: the solenoid and the valve. The solenoid of the solenoid valve converts electrical energy into mechanical energy which, in turn, opens or closes the valve mechanically. A direct acting valve has only a small flow circuit, shown within section E of this diagram (this section is mentioned below as a pilot valve). This diaphragm piloted the solenoid valve multiplies this small flow by using it to control the flow through a much larger orifice.

Solenoid valves may use metal seals or rubber seals, and may also have electrical interfaces to allow for easy control. A spring may be used to hold the solenoid valve opened or closed while the solenoid valve is not activated.

It is important to maintain the pressure and heat inside a steam system. Overheating can cause the system to malfunction and lead to accidents such as explosions. In steam boilers, heat and pressure are continuously being loaded and pumped. To prevent overheating in steam boilers, safety pressure valves are installed.

Safety pressure valves basically prevent the interior of a steam system from rising above the normal temperature and pressure. These safety pressure valves should first be tested before installation and should be regularly checked for leaks to avoid accidents.